anoniem Geplaatst: 5 augustus 2007 Delen Geplaatst: 5 augustus 2007 Door een val is het kleine lock clipje uit mijn SD geheugenkaartje gesprongen en is niet meer te vinden. De kaart zelf is niet beschadigd maar hij is nu tegen veranderingen beveiligd. Ik had nog een 16 MB kaartje liggen en ik besloot eens te gaan kijken hoe dit lock/ unlock mechanisme werkt. Het blijkt een uiterst klein plastic schuifje te zijn. Niets te vinden dat er ergens een elektrisch contact gemaakt of verbroken wordt... Hoe werkt dit? Is het soms mechansch zoals de beveiliging bij een cassette? Weet iemand hoe dit werkt? Jack marotick Quote Link naar reactie
anoniem Geplaatst: 5 augustus 2007 Auteur Delen Geplaatst: 5 augustus 2007 het kan toch misschien zijn dat door dat schuitje een of twee lipjes kort worden gesloten van het kaartje Quote Link naar reactie
anoniem Geplaatst: 5 augustus 2007 Auteur Delen Geplaatst: 5 augustus 2007 [quote:b696651b10="plextor"]het kan toch misschien zijn dat door dat schuifje een of twee lipjes kort worden gesloten van het kaartje[/quote:b696651b10] Het schuifje is geheel van plastic. Ik zie niet in hoe er dus een verbinding gemaakt kan worden. Jack Marotick Quote Link naar reactie
anoniem Geplaatst: 6 augustus 2007 Auteur Delen Geplaatst: 6 augustus 2007 http://en.wikipedia.org/wiki/Secure_Digital_card[quote:f72684f063]Optional write-protect tab When looking at the card from the top (see pictures) there is one required notch on the right side (the side with the diagonal notched corner). On the left side there is usually a slidable tab. This is the write-protect tab. The MMC has neither notch.[b:f72684f063] It is easy to mistake this tab as an electronic on/off switch built inside the card, but it is nothing more than a piece of plastic. The tab / notch works the same way as the notches on compact audio cassettes and videotape cassette tapes or floppy disks. It is up to the device to sense the tab / notch and determine if the card is write-protected or not.[/b:f72684f063] When this write-protect tab is in the down position (away from the end that is inserted) then it is write protected and read-only. When the tab is in the up position it is write enabled. Since the tab is optional, the card can have no switch and no notch, which makes the card always writable, or it can have an empty notch and be a ROM card, or always write-protected and read-only. If the tab becomes broken or falls off then the card will become a write-protected ROM card and no longer be writable. A possible troubleshooting solution would be to apply tape over the notched area (avoiding the connectors and the other notch) to configure the card in a permanent writable state. If the sensor inside the device is faulty and unable to detect the tab / notch, all SD cards will seem to be write-protected. The write protect tab feature is optional within the Secure Digital Association guidelines. Some manufacturers claim that the write switch is easily broken, and do not include it on all their card models[3].[/quote:f72684f063] Quote Link naar reactie
Aanbevolen berichten
Om een reactie te plaatsen, moet je eerst inloggen